The programmer can be used with various 3rd
party software through the Virtual Comport. For use with 3rd party software, the programmer has to be set in a certain
mode (eg phoenix or smartmouse). The 3rd party software determines which mode you
have to select. The mode selecton is only needed to program
the cards not supported natively by CardPro software, such
as Titanium, M2, GSM/SIM-cards etc.
Setting up the programmer is very easy. Start the
Multipro 7 in 1 software and select the mode you need for
the 3rd party software. The MultiPro software will minimize
to systray if you hit the minimize button. Now you can start
the 3rd party software and program your smartcard. Please
note that you have to setup the comport for first use by
selecting the autodetect function under "Options" "Serial
Ports".
The modes can be verified by the LED's on the programmer.
Smartcard connector (1)
LED for data transfer (2)
LED for MHz indication (3)
LED for EEPROM (green)/µcontroller
(red) programming mode (4)
LED power (5)
RS232 cable for
connection with your computer (6)
| Description |
Mode1 |
Mode 2 |
| Idle |
Green |
Off |
| Phoenix 3.57 |
Green |
Off |
| Phoenix 6.00 |
Green |
On |
| Smartmouse 3.57 |
Green |
Off |
| Smartmouse 6.00 |
Green |
On |
| AVR/SPI 3.57 |
Red |
Off |
| AVR/SPI 3.57 |
Red |
On |
| JDM/PIC mode |
Red |
Off |
